This product is best suited for areas where sure footing is required or that become slippery when wet, such as exterior steps, sloping surfaces, laundry floors, pool surrounds, pathways, paving, patios, and walkways.
- Enhances slip resistance to a minimum of a P4 rating
- Fast-drying - touch dry in 30 minutes, ready to recoat in 2 hours, fully dry in 24 hours
- Ready to walk on after 2 hours
- Suitable for low gradient ramps and sloping areas
- Can be used in high UV areas
- Water-resistant against prolonged rain and splashes
- Heat-resistant up to 120°C
- Leaves an attractive low level of sheen in a flat finish
- Covers approximately 12-16m
To apply, check out the Bowens range of brushes , rollers , and spray guns . Don't forget your safety gloves and eye/face protection . This product is not suitable for use on timber decking, stencilled concrete, or patterned sealed concrete. It is also not suitable for commercial areas and heavily stained or badly worn traffic areas impregnated with rubber, plastic or leather, or where the aggregate is showing through the surface. Bowens recommends taking care if using this product on garage/carport floors, driveways, and other surfaces involving cars. Flat finishes are more susceptible to marking and wear than other Berger® Jet Dry® coatings. If surface marking is an issue, check out Berger® Jet Dry® Gloss instead. For better performance in areas subject to vehicular traffic, it is recommended you use Berger® Jet Dry® Heavy Duty or Rapid Tread™ with Berger® Jet Dry® True Grip® Clear instead.

